← Back to work
BUILDINGWorking prototype · Exhibited at ZAS 2026

FishTech Feeder

A standalone, solar-powered automatic fish feeder in welded steel, for smallholder ponds in Zimbabwe. The first unit is built and dispensing feed.

Stage
Working prototype
Shown at
Zimbabwe Agricultural Show 2026
Sizes
F10 (10 kg) and F25 (25 kg)

The first unit spreading feed over a pond.

What it is

A hopper holds one bag of floating pellets, and the machine feeds the right amount, more often and more evenly, on a schedule. It is never sold as a way to feed more.

It runs on its own, with no internet, on a small solar panel. When the FishTech Precision Feeding System is at the same pond, it can take a grams-per-feed instruction from it over Wi-Fi, but it sells and runs without it. It is a working prototype: the dose test is not written up yet, so no accuracy figure is claimed.

What it does

Meters each dose

An auger turns a counted number of revolutions for each dose. Metering is by counted revolutions, never by time.

Spreads it over the water

The dose falls onto a spinning disc below the box. A shroud around the back of the disc sends feed only toward the pond.

Works out the ration

From fish size and water temperature, read by a probe on a float, split into small feeds through the day.

Stays within safe limits

The daily total is capped by pond area, and the farmer is told when the cap is reached. It warns when more than 14 days of feed is loaded.

Counted, cross-checked, safe when off.

An ESP32 controller with a battery-backed clock keeps the feeding schedule for months without internet. A hall-effect sensor counts the auger's revolutions. The design compares the time a dose takes with the revolutions counted and stops with a fault if they disagree, because a lost magnet would otherwise mean an over-dose that reports success.

The motor drivers are wired so both motors stay off while the controller starts up. On a jam the machine stops, logs it and reports a partial dose. The auger is a cartridge that comes out through the door.

Water temperature from a probe on a float, and optionally a grams-per-feed instruction from Iris over Wi-Fi, reach the ESP32 controller with its clock, feed table and pond-area cap. It turns the auger a counted number of revolutions, checked by a hall sensor, and the dose falls onto a spinning disc that spreads it toward the water.

Stack

Electronics
  • ESP32-WROOM-32
  • DS3231 real-time clock
  • DS18B20 water temperature probe
  • Hall-effect sensors
  • MOSFET motor drivers
Power
  • 20 W solar panel
  • 12 V battery inside the box
  • Solar charge controller
Build
  • Welded mild steel, galvanised sheet
  • Rolled-cone hopper
  • Arduino on PlatformIO
  • Parametric CAD in build123d (Python)

Screens

Photos of the first unit. Tap one to open it.

Building hardware that has to work without the internet?

Embedded control, solar power and firmware that fails safe. The same approach fits other farm and field machines.

Start a conversation